|
Post by sandy on Mar 26, 2023 12:03:33 GMT
while fitting a front wheel I found this spacer fitted to the spindle. None of my others have the lip at the bottom, anyone know what it's from? I wonder if the reverse comstars have a different spacer? can't find any info on these though. internal/external diameter and depth is the same as the normal spacer, total depth is 10mm +3mm for the lip.
|
|
|
Post by buster on Mar 26, 2023 13:53:16 GMT
that looks a little bit like the spacer I'm currently looking for to fit my boomerang rear wheel
|
|
|
Post by sandy on Mar 26, 2023 14:36:52 GMT
Buster, weren't you looking for a spacer for the rear wheel? this won't fit the rear, it is the right internal diameter for the front wheel spindle.
I was just interested in what type of wheel it might be for. I don't need it and will likely never use it if it's no good for comstar or reverse comstar wheels.
|
|
|
Post by buster on Mar 26, 2023 15:38:11 GMT
yep its rear that I'm looking for and your right I did a bit of picture measuring and thought the internal diameter was too small, back to searching or more likely have one made
|
|
|
Post by BritPete on Mar 26, 2023 16:12:12 GMT
yep its rear that I'm looking for and your right I did a bit of picture measuring and thought the internal diameter was too small, back to searching or more likely have one made Or drill it out
|
|
|
Post by buster on Mar 26, 2023 16:24:39 GMT
yep its rear that I'm looking for and your right I did a bit of picture measuring and thought the internal diameter was too small, back to searching or more likely have one made Or drill it out depends on quite a few things though, outer diameter at the smaller end (to fit the seal on the sprocket carrier) and overall length. there is a small engineers lathe for sale on ebay thats not too far from me, that would probably do the job (and a few others that I'v got in mind) I'll see how the bidding goes
|
|
|
Post by BritPete on Mar 26, 2023 16:36:48 GMT
DFS is handy on a lathe in his garage
|
|
|
Post by davefirestorm on Apr 3, 2023 12:26:58 GMT
As BP said I’ve a lathe in me garage if you want a spacer making to your dimensions ( applies to anyone 😁 )
|
|